The machine can feed paper from the standard paper tray or manual feed slot. When you insert paper into the paper tray, please note the following: If the application software supports selecting the paper size to print menu, you can select it via the software. If your application software does not support it, you can set the paper size in the printer or driver using the keys on the control panel. Before using paper that has holes in it, as the organizer, you must 'vent' pile to avoid paper jams and jams. Printing on plain paper, recycled paper or transparencies from the paper tray. Pull the paper tray completely from the machine. While pressing the Green Paper Guide release lever, slide the paper guides to fit the paper size. Ensure that guides are firmly in the slots. Load paper in the tray and make sure that the paper is below the maximum paper mark (1). The side to be printed should be upside down. To avoid damage to the equipment caused by a paper jam, make sure the paper guides touch the sides of the paper. Replace the paper tray firmly into the machine. Make sure it is fully inserted in the machine. Unfold the flap bracket (1) to ensure that the paper tray out upside down.
You can load envelopes and the special one print media at the same time in this slot. Use the manual feed slot to print or copy on labels, envelopes or thicker paper. Printing on plain paper, recycled paper or transparencies from the manual feed slot. The machine automatically activated the manual feed mode when you put paper in the manual feed slot. Lift the flap bracket (1) to prevent paper exit tray output upside down or remove each page as soon as it comes out of the machine. With both hands, slide the manual feed slot paper guides to the width of the paper you are using. With both hands, place a sheet of paper or a transparency in the manual feed slot until the front edge touches the paper feed roller. When you feel that the machine pulls the paper, release.
0 Response to "Brother MFC-7840W Manual"